I am looking for software help on a CAN interface that is on the TI CP3UB26 microcontroller as well as on the NatSemi/TI CR16 family. Does TI have any software drivers for this CAN peripheral? Thank ...

Note - all references to issuing commands and displaying data refer to the use of BQStudio and an EV2400. Also just to provide context, I have a BQ27520EVM connected to a BQ41Z50EVM, and my ultimate ...

Page 4 of SLUUD32 says "Find the latest firmware in the appropriate BQ41Z50 folder on www.ti.com". Where can the actual *.bq.fs file be found (need the file, or a better link than just www.ti.com).

The open-loop gain in the simulation result (59.9V/mV) is smaller than the minimum value (70V/mV) in the datasheet. Does this mean that the gain in the SPICE model is smaller than the gain in the ...

I have some questions about the manual. 1.Which register does this reset refer to?FRAME_CNT_THRESHOLD(46H) or FRAME_CNTx(45H)? 2.Is the error counter mentioned in the ...

We are using TCAN1145-Q1 to judge it is wake up frame from the network or not by CANINT register bit. While we found when there are other nodes receiving WUF, this TCAN1145 node cannot assert register ...

Reg63 ”DAC Channel Volume Control's Soft-Step control”...Soft-Stepping is 1 step per 1 or 2 DAC Word Clock I would like to check whether there is any pop noise when switching from maximum volume to ...

I met the similar problem when using ads1274EVM-PDK, And of course, the USB device was enumenated under NI-VISA USB Devices: My PC is Windows 10 64 bit. In C:\Program Files (x86)\ADCPro\drivers ...

This question is similar to "e2e.ti.com/.../bq25756-driving-the-system-when-the-battery-is-absent", I don't see an answer to that question, so I am asking here. We ...

I am currently working on a project that involves the AM62X platform, and I am encountering an issue when trying to configure GPIO interrupts. I would greatly appreciate your guidance in understanding ...

We are using Code Composer Studio Version: 12.8.0.00012 with compiler version 22.6.1LTS, C2000Ware version 5.2.0 and SysConfig version 1.21.0. We have configured two tasks to run on CLA. Basically ...

If the customer is using bandgap reference, I would suggest to follow the table below. REF35, REF34 are reasonable cost. Depending on your accuracy requirements over temperature, REF35 or equivalent ...